Wera 074826-010 Custom Pre-Set Fixed Torque ESD Screwdriver, 0.1 - 0.34 Nm

Wera 074826-010 Custom Pre-Set Fixed Torque ESD Screwdriver, 0.1 - 0.34 NmWera 074826 010 Custom Pre Set Fixed Torque ESD Screwdriver, 0. 1 0. 34 Nm For any application where the same constant torque and repeat accuracy are required ESD construction for safe protection against electrostatic charge and associated damage. Suitable for bits with 4 mm halfmoon or 4 mm HIOS drive Desired fixed torque setting can be specified in the following units: Nm, kgf. m, lbf. ft., ozf. in., dN. m, kgf. cm, lbf. in, in. oz, cN. m, gf. m,

Wera 074826-010 Custom Pre-Set Fixed Torque ESD Screwdriver, 0.1 - 0.34 Nm

For any application where the same constant torque and repeat accuracy are required
ESD construction for safe protection against electrostatic charge and associated damage.
Suitable for bits with 4 mm halfmoon or 4 mm HIOS drive
Desired fixed torque setting can be specified in the following units: Nm, kgf. m, lbf. ft., ozf. in., dN. m, kgf. cm, lbf. in, in. oz, cN. m, gf. m, ft. lb, gf. cm, in. lb.
Factory pre-set torque screwdriver with Rapidaptor quick-release chuck
Fixed value can be easily adjusted between 0.1 and 0.34 Nm using Wera's Recalibration Kit and any appropriate torque tester
Rapidaptor technology for rapid bit change
Distinct audible and tactile signal when pre-set value is reached
Multi-component Kraftform handle for high working speeds
Unlimited counter-clockwise torque for loosening stuck screws
Handle length: 89 mm
Total length: 138 mm
Manufacturer's part number 05074826010

Note: this screwdriver is pre-set at the factory and requires a specified torque value at the time of ordering.